Cetme scope mount?

[bsllvn]

Where can I get a good scope mount for a Cetme??

Thanks!

[Richard Simmons]

Try B-Square. I've read some good posts about these for the Cetme. Some folks have replaced the tightening knob with an allen head bolt to get more torque when tightening. As I understand it the claw mounts require a bit of flex in the receiver to latch down properly. The cast receivers don't have this flex therefore some filing of the mount or the receiver may be required for a proper fit. I've never compared my cast against a stamped receiver but a recent SGN article made mention that the stamped receiver lacks a stop to keep the mount from shifting under recoil. I've not scoped mine so this is all just second hand info. HTH

[bsllvn]

Richard -

I looked on B-Square's website - didn't see anything there ...

[smittylite]

Tapco has one of the claw-type ones for the HK91-G3 rifle. I think it would work on a CETME.

[Richard Simmons]

http://www.reliablehost.com/bsquare/page2.html

Check the HK link

[bsllvn]

Thanks guys I'll take a look.

Bill

[Tony@TAPCO]

Our scope mount is $59.99 and will work like a charm on that Cetme. They are in stock and ready to ship.

[RetVet]

FAC also lists one in their flyer, a low optic mount, G3LOWMNT, $54.99. I haven't read any feedback on them, but they look good.

The B-square mount looks a bit goofy with that big knob it has.

[CETME]

I love MINE!!

http://www.gunsnet.net/album/data/3015/7746CETMEscope-med.jpg

http://www.gunsnet.net/album/data/3015/7746CETME-med.jpg