lower receiver ?

[Tomac Yokctep]

I'm putting a lower receiver together (Stinger Arms ) and the holes for the hammer and trigger pins are smaller then the pins that I have (Colt parts ) the pins fit the hammer and trigger ok but will not go through the holes in the receiver .I talked with a gun smith and he said that he can drill the holes bigger ,what do you think ? :rolleyes:

[Pappyo]

you've got the oddball Colt LARGE pin lower parts set. They were made for civilian AR's for awhile.
DON'T drill your hammer,trigger holes in your reciever. Just get mil spec. small pin AR15 hammer,trigger, and pins for your mil spec Stinger lower. Try to sell your large pin stuff!

[Tomac Yokctep]

Thanks I'll try to get another hammer and trigger .:mad:

[oclvtrek]

Try these places for mil-spec trigger & hammer parts:

Bushmaster (http://www.bushmaster.com)
ADCO (http://www.adcofirearms.com)

[Silver Dollar]

I've seen pins advertised for just that situation.
I forget who makes them, DPMS maybe, but I know that they are available.

If I can find where I saw them, I will post a link

[Tomac Yokctep]

Thanks everyone I took care of it.:cool: