Buffer for the FNC?

[tkharris]

I noticed that you previously mentioned producing a buffer for the FNC (New releases will include a buffer for the FAL, SVD/NDM-86, and FNC, and Uzi-semiauto) and I was wondering if it was still in the works.

I have an FNC which would really appreciate it.

[Blackjack]

The FNC buffer is being molded and should be available in a couple of weeks.

[Blackjack]

The FNC buffers are now available, $9.95 ea.

http://blackjackbuffers.com/FNCm.jpg

[tkharris]

Great. You will get my order shortly. I could not find it on your website so I will just write in FNC on your order form and send you a check. Thanks

[Blackjack]

Well you're right, it's not there anymore. :confused: I'll have to get it back up.

[hcpookie]

The FNC buffer rocks! That's all I can say about it. The reduction in recoil was noticeable... perhaps not as much as with the AK but still noticeable. I have no way to measure or quantify the difference.

The buffering this provides between that rear plate on the spring retainer & the rear of the bolt carrier will undoubtedly extend the life of these rare parts.

Wouldn't be so big of an issue if parts were as common as the FAL! ;)

In case you're curious, I have some pics of the buffer in the rifle on my website here, along with the prototype (the red one). Its been fun getting it custom-fit & fine tuned!

http://pookieweb.dyndns.org:61129/FNC/FNC_Buffer_Plate/fnc_buffer.htm


Thanks again Randy!!!

- Jerry

[Blackjack]

Jerry,
Thanks again for all you hard work in helping me develop this buffer as well as the Uzi buffer project (which is now complete). If any of you guys have firearms that need buffers that I don't already produce contact me and I may consider building a custom buffer as I did the FNC, SVD, NDM-86, and UZI...all of these buffers were co-designed by owners that saw the need.