Bushy M4A3 and EoTech sights??

[R.H.Scott]

Have a Bushy M4A3 that I will be putting a Model 511 sight on the flattop. Do they co-witness OK or are spacers needed on the rail to lift the sight?
Is there a better or cheaper place to get a GI side sling adaptor for this rifle than the Bushmaster web site? If so, where?

Also will be getting a pair of rail handguards with the rail made in at the 12 and 6 o'clock position. Any suggestions?

As the rifle uses the full length buffer, I assume that it has fewer cycle problems that those that use short buffers????

Thanks. I have been issued a M4A1 that has been near and dear lately, but the Bushy is just a bit different as it has a non closing stock and does not go full auto.
Any info or suggestions will help.

[RJ Shooter]

EOTech co-witnesses perfectly with my backup iron sights!!!!!

http://home.earthlink.net/~roglisaj/gunsnet/M4-angle1.jpg
http://home.earthlink.net/~roglisaj/gunsnet/M4-angle2.jpg

Don't have the BUIS flipped up in this pic, but you can get the idea that the sights are in line...
http://home.earthlink.net/~roglisaj/gunsnet/eotech-dot.jpg

Any questions, just holler!!!! :D

[R.H.Scott]

Good to hear.

Now, what kind of pistol grip do you have.
What kind of flashlight is that and the mount it is in and last, where did you get the side sling mount????

Those three shoud be easy.

[RJ Shooter]

Hogue Rear grip - KAC Foreward Grip

Old Surefire light (can't remember model) and Fobus mount (has since been switched to a GG&G tactical offset light mount and 1" quick detach ring).

Wilderness Giles 3-point sling with quick-detach buckle. Mounted to a Bushmaster front side-sling mount and rear GG&G Rear Sling Thing...