Carbon 15 "pistol"

[Ozacu]

Can the Carbon rifle stock be installed onto the back of the pistol? Does it work?

[RJ Shooter]

No, they purposely leave the catch for the stock, off the pistol versions, so they cannot be attached. They are legally created as pistols (serial #s are listed as pistols), and putting a stock on one would create a short barrelled rifle.

Having an unregistered SBR is a federal offense and punishable by prison. ;)

[JE3146]

yea that'd be a no no.. howevor.. one could take a stripped lower after the ban sunsets and register it as a PISTOL reciever.. then you may freely at your will change the configuration between a pistol and a rifle, howevor you must do this in such an order that you dont create an illegal weapon in the process of doing so... I forget what in the assault weapons ban prohibits from doing this now.:confused: but I heard it can be done later... :D after the 14th

only disadvantage is if you were hoping for the carbon model... but this provides an alternative

[Coils]

I'm glad to see this topic. I got a Bush Master pistol and was thinking of getting a rifle parts kit so I could switch the receiver from a pistol to a rifle and back again. Is this possible? And what is the "catch for the stock" that RJ mentoined? I figured if I could do this it would save me hundreds of dollars instead of buying an assembled rifle.
Thanks
John

[JE3146]

I beleive its a bored hole on the threaded end of the reciever if I'm not mistaken... just below the threaded buffer tube hole... isn't that it RJ?

[Coils]

Thanks JE. I think I might be able to use mine then, under the buffer tube that sticks out the back is a piece of shaped plastic that is screwed on to cover something up (I never removed it yet) and give it a finished look. The screw is between 1/4 to 1/2 of an inch down from the bottom of the tube. Now I'm going to have to take it off to check it out.
Thanks again.
John

[JE3146]

glad to be of service.. just.. hope I was right lol :D