ejector

[cbert04401]

i just received a bolt buffer,hammer ,and ejector. Can I replace all 3 myself?
Are there instructions somewhere?

[Jericho]

Yes you can change them yourself. It is just part to part replacement. Here is a break down picture for e-gunparts.
http://www.e-gunparts.com/schemzoom.asp?schem=1910z10-22

This is it the best I can remember. Just remember where all parts are located before you remove them...

The bolt buffer replaces pin #10.
To remove the hammer you must remove pin #32 and spring #9 will come lose and part #15 will come out. You then remove pin #26 and pull the hammer out. When you pull the hammer out spring #9 will come out as well as the shimmes #25 and the parts (#26,27,29) may come out (it will be one unit). Just keep an eye on how all parts are placed before you remove them. You install it by doing the reverse. When you reinstall pin #24 you just make sure to have the spring #9 set right and push the apring below the pin.
And for the extractor if I remember correctly it is just pinned in.

Here is another picture but the numbers do not corolate to my directions

http://www.geocities.com/Yosemite/Geyser/1720/trgroup.jpg

[cbert04401]

Thanks,buddy.
I'll give it a try