M-92 pistol build 1.0 mm or 1.6 mm reciever?

[Ivan Jaknov]

OK I have my M-92 kit, pressed out the barrel stripped off the stub reciever, by the way I found some rust between the trunion and reciever stub. Cleaned everything up and am ready to start building it back up into a pistol. Had planned to use a Global 1.6 mm reciever then I read the add by Atlantic saying that the Global 1.0 mm reciever is the way to go. I have both recievers in house so which is it the 1.0 mm or the 1.6 mm reciever? Actually I have seen two adds by Atlantic one refrences the 1.6 mm reciever the other speaks of the 1.0 mm reciever being the clear preference. What do you guys think is one prefrable over the other for this build?

[SLAMFIRE51]

I haven't heard whether the M-92 orginially uses the 1.6 mm receiver.
If it doesn't, using a 1.6 mm receiver would require you to mill the trunions.
I would go with the 1.0.

[thealien]

1mm, thats what you stripped off. If it was good enough for them in full auto I am confident it will be fine for semi auto.