Sten Mk III Template

[GonzoX]

Not sure if this is OT or Taboo here but will try anyway.

My Son has a Sten Mk III parts kit and wants to cut PCV pipe to make a receiver for it so he can have a Sten dummy gun.

Anybody here know of a free one available?

All I can find on the web are the Mk V ones and they are different than the Mk III.

[Steven Mace]

GonzoX, would this work for you?

http://www.gungarage.com/partskits.htm

Steve Mace

[Rew]

Not close to taboo.;)

[GonzoX]

Thx guys. I emailed gungarage and they no longer stock the tubes.

On the bright side, I did find a free template via P2P so now I must go out and get the right size PVC pipe and a dremel kit for Jr.

[GonzoX]

OK, need some help here.

I have a 1.5inch PVC tube and noticed that after printing Mk III template that the end of the template does not line up with the other end.

Instread of the ends meeting in the middle there is a 1/8inch space between the two paper ends. Is this normal? Did I print it wrong?

Also wanted to know how do I remove the mag well from the cut up receiver?

And what about the barrel? If I grind off the rivet heads from the outside, will the barrel just slide out with it's two houseing donuts (not sure what they are called)?

Any info would be appreciated.

[fordracer1@msn.com]

mark 2 template is same as mark 3 just lengthen mark 2 template and leave out half moon cut out on end of 2 temp.