sweede
12-27-2000, 11:09 PM
This keeps coming up... Probably becuase the prices for Chinese drums are the lowest they have been in the last 2 years.
75-round drum mag:
1. Open the drum with the lid facing towards you. 2. Depress the SRING RELEASE BUTTON, disk in middle with a gear tooth on each side. If it pops and makes you want to jump, it’s just releasing tension on the spring. 3. Next while the spring release is held down, turn the feed wheel clockwise (3 times for a 75 round mag) until it comes to a stop. 4. Begin by inserting 3 rounds bullet-end down from underneath.. not through the top like a 30-round mag... into the vertical feed (part that is inserted into the receiver). The rectangular divider next to the ramp at the 12 o’clock position takes 6 rounds and the small circular partitions along the perimeter take 1 round each. The last partition with the follower at the 11 o’clock position takes 4 rounds. Complete filling the rest of the partitions (notice how there is a corkscrew channel guide for the bullets) and close/latch cover. 5. Turn crank 5 full revolutions clockwise. 6. Sling lead... try not to overheat the barrel!!!
75-round drum mag:
1. Open the drum with the lid facing towards you. 2. Depress the SRING RELEASE BUTTON, disk in middle with a gear tooth on each side. If it pops and makes you want to jump, it’s just releasing tension on the spring. 3. Next while the spring release is held down, turn the feed wheel clockwise (3 times for a 75 round mag) until it comes to a stop. 4. Begin by inserting 3 rounds bullet-end down from underneath.. not through the top like a 30-round mag... into the vertical feed (part that is inserted into the receiver). The rectangular divider next to the ramp at the 12 o’clock position takes 6 rounds and the small circular partitions along the perimeter take 1 round each. The last partition with the follower at the 11 o’clock position takes 4 rounds. Complete filling the rest of the partitions (notice how there is a corkscrew channel guide for the bullets) and close/latch cover. 5. Turn crank 5 full revolutions clockwise. 6. Sling lead... try not to overheat the barrel!!!