PDA

View Full Version : Molina Grips


REDSTAR
08-06-2002, 09:22 AM
Got my Ballester Molina and Riguad yesterday, mine had nice barrels, both are in great functioning order, no blue, a small rust patch here and there.

The Molina has terrible grips however, pieces of the wood are broken off near the screws.. I remember someone was selling the new orangish colored grips like on the refinished ones, anyone remeber who has those?? Or anywhere for wood grips??

REDSTAR
08-06-2002, 09:49 AM
Never mind, it was JLD Enterprises where I saw them. I just ordered two sets for $13 each with screws. These are the walnut (orangeish colored) grips they put on the refinished ones I believe. Whatever they are they say walnut, and they are sure to be better than the ones I have. He wasn't sure if they fit the Rigaud or not but at that price I ordered two sets anyway.

Great price! They are very nice folks there I highly recomend them so far. I asked about Sistemas and Molinas and they are expecting a large shipment at the end of the month.

www.jdlenter.com

I didn't see any barrels Ecoli but you may want to call and ask them. 860-676-1776

SalBO
08-06-2002, 09:54 AM
they fit both the Rigaud and Ballester RedStar. They are the same as on the rearsenalled that SOG sells. I also ordered two sets. I did sand them down a little and restained a bit darker . They are solid walnut and not a bad grip after sanding down the sharp grooves in them.....

REDSTAR
08-06-2002, 09:55 AM
Thanks Salbo :)