Need help with rifle problems

[quick_silver90]

I just bought a m48a and this is my first time taking the rifle apart. So I am a newbe at this and I think I got myself into trouble.
I the rifle work safty worked fine before I cleaned it, know after I cleaned the bolt the saftey is stuck on the firing postion and even a slug hammer will no move it.

I took out the bolt assembly out again and know the bolt is stuck toghter, I cann't take it apart becasue the safty is stuck to the left in the firing postion. I beleive it has to point stariaght up in a safty postion in order for you to seperate the assemble. It will not allow me to depress the plunger and turn the bolt to seperate the assembly like I did before when I first cleaned the rifle.

This bolt assembley is stuck togher and no matter how much I swivil it around and pull its stuck.
Any sugestions on how to seperate my stuck bolt and its housing?
Thank you,

[smittylite]

Slide the bolt assy back into the receiver as if you were chambering a round. Close the bolt. See if you can now move the safety.

[quick_silver90]

I tried that already but no luck!

[smittylite]

check out your post in the Czech/Yugo section.