PDA

View Full Version : Where to get RPK laminated stock set

bulgarianak
10-23-2002, 07:30 PM
Anyone know where I can get a laminated RPK stock set for a milled receiver?:beltfeed:
sfc ret
10-23-2002, 08:29 PM
you might have to take a stock for a stamped one and modify it to fit a milled receiver...

http://www.interordnance.com/Merchant2/merchant.mv?Screen=PROD&Store_Code=INTERORDNANCE.com&Product_Code=RPK2000
bulgarianak
11-04-2002, 03:39 AM
How hard is it to modify a stamped butt stock over to a milled? I know sanding is needed, but will it fit with only sanding off the tip or is there some type of shim that is needed?
PeeWee
11-13-2002, 11:17 PM
I saw some at www.auctionarms.com and www.gunbroker.com go to the sites and use thier search eng.
AbyssDncr
11-14-2002, 11:33 AM
Originally posted by bulgarianak
How hard is it to modify a stamped butt stock over to a milled? I know sanding is needed, but will it fit with only sanding off the tip or is there some type of shim that is needed?

In comparing my stamped stocks to an SLR, it looks like you'd just have to cut the nub off the front of the stock and if you have the lower tang, you'll need to inlet that too. FYI, I mentioned my SGN ad to IO last week and they honored the ad for a new laminated RPK stock with gas tube: $35. Should be here Monday!
automaticdan
12-07-2002, 10:53 PM
Originally posted by AbyssDncr
In comparing my stamped stocks to an SLR, it looks like you'd just have to cut the nub off the front of the stock and if you have the lower tang, you'll need to inlet that too. FYI, I mentioned my SGN ad to IO last week and they honored the ad for a new laminated RPK stock with gas tube: $35. Should be here Monday! I got mine a couple of days ago the handguards do not fit my SAR-1 but the stock does it looks great but has some dings not bad for $35:D