I would like to know if anyone can help me with an issue I am having on my Yugo M70AB2T rifle involving an issue with adjusting the front sight.
My rifle is firing below the point of aim through my sights. Upon adjusting my front side to correct this issue, I ran out of threads on the adjustment which still needs to be screwed down further to get the sites in properly. To make matters worst, even if I could screw this piece down further, it would completely disappear into the front site, and this still wouldnt resolve the problem as it appears that the sight itself is just too tall altogether to get the rifle properly aligned!! Its as if the sight itself, the whole piece, is just too tall and no amount of adjustment will work!!
For the time being, I have since raised my rear site leaf up to the "5" selection and this has raised the rear enough to allow my sites to properly align with the laser dot,(I am using a laser SightMark to adjust my sites) but obviously, this is not desirable and only a temporary solution.
So does anyone know what I need to do at this point to properly align my sights in?? I would really appreciate any suggestions, thanks a lot.
Reply With Quote
Originally Posted by romak10/63UF
Unfortunately, it appears that no matter how much I screw in or sand that threaded piece shown in your link, it is beyond that part altogether. Even if I completely remove that threaded piece, the whole front site itself is completely too high from sighting my rifle in. Its as if the front site itself is way too tall for my gun or either my rear site is way too low for my gun!! 
Bookmarks