EPS Directorate to (filthy phil).
show details 9/22/06
Thank you for visiting ATF's Website. As stated on our site, generally,
we do not answer technical questions via e-mail, but I contacted our
Firearms Technology Branch (FTB) and was advised the following:
"If you manufacture the firearm yourself (cut off the barrel), no
additional markings other than the original markings are required. If a
Class III manufacturer cuts the barrel, the weapon must be marked by the
license holder. The serial number would remain the same in both
instances."
If you have any further questions, please call them on 304-260-1700.
Regards,
-----Original Message-----
From: (filthy phil) [xxxxxx@yahoo.com]
Sent: Monday, September 18, 2006 6:52 PM
To: EPS Directorate
Subject: required markings for sbr
sirs,
please advise me of any required markings or engravings for my uzi short
bbl rifle, approved march 30, 2006.
i flled out the required info on the form 1 that was approved. this
weapon is registered under my llc, and am hearing conflicting info
regarding any additional makings or engravings required. of course i
wish to remain in compliance.
thank you
filthy phil
owner
filthy enterprises llc
Bookmarks