Any recommendations?

I have a Yugo RPK kit and the correct milled receiver for it an while I was installing the barrel the tool broke. So now I have a partially pushed in barrel.
I need an AK gunsmith that can remove the barrel without screwing up the receiver because I don't think you can get these anymore and then complete the build, without refinishing it.

If anybody HERE can do this I will gladly pay you.

It needs:
* Removal of barrel and probably a clean up of any burrs.
* Reinstallation of barrel/headspace, pin.
* Trigger guard and mag catch installed.

* Just all of the hard stuff.


BISHOP