anyone know a good place to get them from?
anyone know a good place to get them from?
I've been meaning to get one from these guys for a while:
http://www.buymilsurp.com/bolt-body-...ifle-p-75.html
So I don;t have to chop up an original, choo know?
Good luck!
Thanks, I don't really want to send the only one I have out to someone I don't know, rather just buy one. I will will try these guys.
Here's a guys website that does excellent work.
http://www.angelfire.com/gundam/boltman/bolt_work/
Here's mine I modified using an AK piston shaft and original ball.
There's no problem an AK can't solve...........
GUNSNET Member Since 2003
CCW Permit
03 FFL
Nice job! now I have to buy another one and try that myself! thanks alot!
Boltman does a really good job on the turndown bolts. I am actually sending two Mauser bolts to him.
Boltman mods them and outright sells them.
He did one of mine, super and nicely polished.
Sarco has the bolt body for $10 or 15 each and they are super easy to modify your self with a drill press,vice,and a mig welder.I cut the ball off and drill a under size blind hole for the rod size then squish the ball on the shaft in the vice,Then I chuck it in my cordless drill and sand /polish any vice/ hammer marks on a belt sander be fore I bent it in a wood lined vice.I used 5/16 stainless rod and then mig'ed it to the body...cleaned up the welds with a flap wheel grinder then polish or sand blast ....kman
I've even drilled the body and silver soldered the shaft in to it.
Last edited by a-kmanator; 08-14-2010 at 10:50 PM.
Damn, that's NICE.
Hey what about the metallic stock? Pics please.
There's no problem an AK can't solve...........
GUNSNET Member Since 2003
CCW Permit
03 FFL
Originally Posted by ;4396
There you are smittylite.
I am sitting in my angry chair!
That's my KM91 build...http://www.gunsnet.net/showthread.ph...bubba-done-now!
I followed the link, very nice write up.
Did you use an AK bending jig?
There's no problem an AK can't solve...........
GUNSNET Member Since 2003
CCW Permit
03 FFL
Bookmarks