View Full Version : ak74 ejector
eddie3911
05-29-2011, 07:26 PM
how can i fix the ejector on my 74, its not ejecting anymore
Wire welder, dremel tool and pin files. Sometimes you can brace the bottom of the ejector and from the top side use a small center punch and hammer to peen it out a bit. This will usually give it a little more length but is certainly not a permanent fix. Sounds like it wasn't hardened and has worn down.
Although I cant see it happening, are you sure it's the ejector and not the extractor spring. There could be some trash or case slivers lodged under the extractor that are interfering with it's ability to pivot.
eddie3911
06-12-2011, 09:25 PM
i will check that out, i lined up my other 74 to it side by side and they are the same lenght, thanks JOJO.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.