PDA

View Full Version : Jard trigger installation in an AK-47 Variant



salvadlj
04-25-2013, 08:40 PM
Hello Gentlemen,

I just joined the website - love my AKs - use them in 3 gun competition instead of my AR-15s.

Anyway I have installed a Jard 3.5 lb trigger assembly in my WASR (from Romania), and am trying to get all the adjustments correct. The instructions that came with the trigger assembly leaves a lot to be desired. Four set screws need to be adjusted, 1 for overtravel, 1 for disconnector adjustment, 1 for the actual hammer release, and 1 for the safety.

Has anyone done this or know about it? I have it "adjusted" I think but am a little leary of this setup.

Thanks in advance for sharing your knowledge and information - I enjoy reading what is written in this forum.

God bless the USA.

Lincoln

salvadlj
04-26-2013, 08:31 PM
Follow on question:
Does anyone have experience with other AK triggers such as the ones built by RedState or Arsenal or other? I have experience with the Tapco triggers...

Thanks,
Lincoln