PDA

View Full Version : Loads for .357 Magnum?



JTHunter
06-16-2014, 04:32 PM
How many of you reload .38 Special or .357 Magnum?
A relative has an SP101 snubbie and I have a 4" GP100 and I'm looking for "recipes" for both. I'm particularly interested in JSPs or JHPs for the .357 that are above 140 grains.
I have been saving our brass but don't yet have dies for my Lee press. What I need to learn (and the internet hasn't been all that "helpful") is what primer to use (small/large pistol, magnum pistol), and preferably ONE type of powder that could be used for both 125 gr. AND 158 gr. bullets.
If anybody has links to that type of info, or has done their own reloads, I would very much like to hear from you!

Thanks!

Viking350
06-16-2014, 04:50 PM
Try this.

http://www.handloads.com/loaddata/default.asp?Caliber=357%20Magnum&Weight=All&type=Handgun

Richard Simmons
06-16-2014, 05:22 PM
Don't have an load data for you but I do own and shoot the snubby SP101. Any load you can shoot comfortably in the GP100 isn't going to feel nearly as good in the SP101. My carries the SP101 now and she uses the .38 Special +P 158gr SWCHP FBI load. IIRC that load runs about 850fps and isn't bad in the Ruger

Schuetzenman
06-16-2014, 06:00 PM
I won't give you grain weight charges but powders I've used for the .357 magnum that worked well are; WW296, H110, Accurate #9. I used these with 158 gr. JHP, SP and hard cast gas checked (I cast them) bullets. I never exceeded maximum loads listed in reloading manuals. However, I did use the max loads most of the time. Mostly used CCI small magnum pistol primers with all those powders.

Helen Keller
06-17-2014, 09:51 AM
hodgdons site is pretty good for info.

BUT IMHO, spend $24 and buy a lyman book .

NAPOTS
06-17-2014, 08:06 PM
hodgdons site is pretty good for info.

BUT IMHO, spend $24 and buy a lyman book .

+1, I wouldn't take anyones special recipe without comparing it against a published reloading manual. That said, I have noticed a HUGE disparity between different manuals. I figure as long as the load is safely below the maximum listed in one of them then it should be good. If you are doing this, pay attention to the COL as the seat depth can influence pressure and I have noticed that that also can vary from manual to manual.

JTHunter
06-18-2014, 08:55 PM
Thanks for all the info people! I figured you could give me some good information and/or links I hadn't found.:D

Darrell
06-20-2014, 01:15 PM
I don't have a recipe off the top of my head but I do have a suggestion. (some don't even think about this) If you shoot .38s in a .357, make sure you clean the chambers well before you go back to magnums.

The .38 builds up a nice little carbon ring, then when you go to the magnums, they can get good and tight from expansion when firing. Extraction can be brutal. I'm talking "wooden mallet" brutal.

Same goes for .44 Special in a .44 mag. chamber and so on. For all who know this great. If not I hope I have saved someone some grief...

JTHunter
06-23-2014, 08:38 PM
Thanks Darrell. I had heard that can cause problems but it never hurts to remind others! :D