BISHOP
02-24-2015, 03:05 PM
Any recommendations?
I have a Yugo RPK kit and the correct milled receiver for it, and while I was installing the barrel the tool broke. So now I have a partially pushed in barrel.
I need an AK gunsmith that can remove the barrel without screwing up the receiver because I don't think you can get these anymore and then complete the build, without refinishing it.
If anybody HERE can do this I will gladly pay you.
It needs:
* Removal of barrel and probably a clean up of any burrs.
* Reinstallation of barrel/headspace, pin.
* Trigger guard and mag catch installed.
* Just all of the hard stuff.
BISHOP
I have a Yugo RPK kit and the correct milled receiver for it, and while I was installing the barrel the tool broke. So now I have a partially pushed in barrel.
I need an AK gunsmith that can remove the barrel without screwing up the receiver because I don't think you can get these anymore and then complete the build, without refinishing it.
If anybody HERE can do this I will gladly pay you.
It needs:
* Removal of barrel and probably a clean up of any burrs.
* Reinstallation of barrel/headspace, pin.
* Trigger guard and mag catch installed.
* Just all of the hard stuff.
BISHOP