Jay
12-13-2010, 12:15 PM
12 ak builds so far all rivet one half weld half rivet all fire fine except for one which I fixed. Trying a PSL build. Barrel came out with some force on a 12 ton press. The pin was really tight. I used some emery paper on the barrel and inside the trunnion just a little and polished. As I was trying to rig my press to fit the long barrel, I took and break and started playing with the barrel and receiver trunnion and started to work the barrel in by hand just enough that it would stay secure just in a few MM and then finished it off with some patient hitting with one of those orange deadblow non marring hammers. it took a few minutes. The barrel can only be moved with the mallet not by hand. I headspaced it all good and then pressed the pin back in. Pin still very very tight fit. Is this rifle safe? Can I weld the barrel to the trunnion to be safe? Everything cycles fine snap cap ejected fine from magazine.. Hold it by the hip and look away the first few rounds???
HELP
:crybaby:
HELP
:crybaby: