romak10/63UF
03-15-2011, 10:27 PM
I know alot of you guys are wondering what the hell ! my wasr 10/63 or wasr 10 or your ak-47 might not feed at all with hollow points... So far i have understood that normal high cap ak-47s most of them do not have this problem but these Wasr 10/63 do end up with feeding problems from the feed ramp... Possable feed ramp polishing ?
I will be useing a dremel polishing tool with my dremel sander tool to be able to get a clean ramp...
Any body else done this please post pictures an explain what tools you used please..
P.s. i have ran over 200 rounds of FMJ out of my new wasr 10/63 it feed 4 out of the 5 hollow points.. the last hollow point almost made it into the chamber... sigh...
I will be useing a dremel polishing tool with my dremel sander tool to be able to get a clean ramp...
Any body else done this please post pictures an explain what tools you used please..
P.s. i have ran over 200 rounds of FMJ out of my new wasr 10/63 it feed 4 out of the 5 hollow points.. the last hollow point almost made it into the chamber... sigh...