and I think I am going to remove the bbl from the frame of the b/p revolver.
reason being. I do not know if it was tightened to factory specs and the bbl is not square with
the frame or if it was just a mess up and the bbl is not square with the frame.

I have talked to 3 machinist and 1 gunsmith and all that comes up is liability issues.
I can't say this or tell you to do this cause if it don't work.........
but gm can kill people. sorry I digress.

couple of questions. Disclaimer by me from me. I will never use this info or suggestions or ideas against anyone!!!! OK?

how do I go about removing the bbl?
I have a vice w 4" jaws.
if I hold the bbl how do I grip the frame
and if I hold the frame how do I grip the bbl?

how can I measure the torque ratio or is it ok to be just good and tight?

just askin. like I said I will never hold a word of this against anyone.