Results 1 to 14 of 14

Thread: AK74 5.45x39 Optics

  1. #1
    Senior Member Escobert's Avatar

    Join Date
    Oct 2011
    Location
    Soviet State of Vermont
    Posts
    110

    AK74 5.45x39 Optics

    Hi guys! Recently got my hands on a ak74. I'd been asking my friend for a couple years to sell it to me and he finally caved. I loved shooting it so much I had to have it.

    My question is where should I go optics wise? It doesn't have a rail or anything on it right now. But, I know a good gunsmith who specializes in AKs so he should be able to get one on for me no problem.

    I'd be looking in the $100+- range. thanks!

  2. #2
    Forum Administrator Schuetzenman's Avatar

    Join Date
    Jul 2010
    Location
    East of Atlanta GA
    Posts
    15,035
    $100+, your choices are limited. I might recommend a Vortex Strikefire II from Midway USA. Right now they should have them on sale for $180 ish. I paid about 190 for mine, like it fine. http://www.midwayusa.com/ Black Friday sales are still on for 2 more days. http://www.midwayusa.com/product/754...ProductFinding They make a red and green dot version that is less but there have been reports of them being dim and washing out in bright daylight. I have the red only version and it has no problems being seen in high noon bright day light.

    Then there is the Vortex Sparc, it is closer to $200 usually. It is a lot smaller and lighter sight, uses a 2032 type coin shaped battery. Midway seems to be out of them at the moment. http://www.brownells.com/optics-moun...turer_1=vortex optics Brownell's has them in stock now.

    Putting an optic on an AK you want to keep it low as possible. There are some top cover replacements that have Pic rails on top of them. They replace the rear sight and then secure to the tang of the rear Trunion. http://www.brownells.com/optics-moun...prod45043.aspx Like this one at Brownell's by Texas Weapon Systems. IMHO these are a better option than the side rails. Those rarely put the optic over the center of the bore, instead they are usually offset to the left quite a bit. They also put the sight higher than I like, though I do have one and it does put it over bore center. I can't remember who makes it, probably was made in Russia or another former Soviet block country. Had it a long time.

  3. #3
    Senior Member ubersoldate's Avatar

    Join Date
    Jul 2010
    Location
    The REDOUBT
    Posts
    1,575
    Kashtan 1P78

    You mentioned $100 plus, and this one is expensive, but well worth it.

    There is a waiting list, but they are floating around. Its made for the 5.45, and its a great optic, I love mine.

  4. #4
    Senior Member Escobert's Avatar

    Join Date
    Oct 2011
    Location
    Soviet State of Vermont
    Posts
    110
    Thanks guys! If it's worth the money I'm willing to pay more would just have to wait a bit longer is all

    I had been looking at some vortex red dots for a sks I was going to get. I liked the look of them. But, a sight made for 5.45 would be ideal. I'll look up the Kashtan 1P78.

    EDIT: Oh wow, yeah that's a bit out of my price range. I'm really liking the Vortex StrikeFire II Red Dot.

    Any specific mounts you guys would recommend?
    Last edited by Escobert; 11-30-2014 at 08:11 PM.

  5. #5
    Contributor 02/2014 FunkyPertwee's Avatar

    Join Date
    Jul 2010
    Posts
    11,163
    I would recomend saving your pennies and buying a Primary Arms Advanced Microdot ($180), along with Ultimak gas tube sight rail (~$100).

    Any mount your gunsmith can rig up is going to cost money.
    "I'm fucking furious, I'm violently angry, and I like it. If you don't know what that feels like then I feel bad for you"

  6. #6
    Administrator imanaknut's Avatar

    Join Date
    Jul 2010
    Location
    Indiana, a state that is trying to remain free.
    Posts
    12,280
    Adding a side mount would allow you to get a scope mount with a rail so that all attachment points are solid and will hold zero or near zero. The problem with a side mount is like FunkyPertwee said, a gunsmith is going to charge you to do it, and the alignment is critical as the mount is riveted to the receiver. Then you add the cost of the scope attachment mount and you are starting to get expensive.

    I agree with the others, that using a gas tube mount with a good red dot would be the preferred way to go in your case. That is unless you have a friend who is a gunsmith who could install the side plate for free or a case of beer, and guarantee it's alignment.

  7. #7
    Senior Member Escobert's Avatar

    Join Date
    Oct 2011
    Location
    Soviet State of Vermont
    Posts
    110
    I would prefer a side mount, I was thinking more in the $100-150 range for the actual scope. And as I said I live in the area of a guy who specializes in working on AKs so I had been expecting some cost with installation. Byt if anyone could point me in the direction of a complete setup rail and complete scope & mount that would work well with the gun that would be awesome.

    Sorry, I've never put a scope on anything before. I had a maadi for a few years and otherwise just shotguns.

  8. #8
    Administrator imanaknut's Avatar

    Join Date
    Jul 2010
    Location
    Indiana, a state that is trying to remain free.
    Posts
    12,280
    Check here for side mounts and the rail, more than you can imagine: http://kalinkaoptics.com/

  9. #9
    Senior Member Escobert's Avatar

    Join Date
    Oct 2011
    Location
    Soviet State of Vermont
    Posts
    110
    So if I were to get this http://kalinkaoptics.com/rifle-scope...k-version.html would I need to get a side mount as well? thanks!
    Last edited by Escobert; 12-01-2014 at 12:12 AM.

  10. #10
    Contributor 02/2014 FunkyPertwee's Avatar

    Join Date
    Jul 2010
    Posts
    11,163
    Quote Originally Posted by Escobert View Post
    So if I were to get this http://kalinkaoptics.com/rifle-scope...k-version.html would I need to get a side mount as well? thanks!
    You would only need the siderail.

    That should make a nice setup IMO, if your gunsmith does his part.
    "I'm fucking furious, I'm violently angry, and I like it. If you don't know what that feels like then I feel bad for you"

  11. #11
    Senior Member Escobert's Avatar

    Join Date
    Oct 2011
    Location
    Soviet State of Vermont
    Posts
    110
    so this guy? http://kalinkaoptics.com/mounts/ak-v...aver-rail.html
    Thanks for the info guys! I agree I think saving a bit more and getting something nice for it will work out in the long run. Thanks again.
    Last edited by Escobert; 12-01-2014 at 12:23 AM.

  12. #12
    Contributor 02/2014 FunkyPertwee's Avatar

    Join Date
    Jul 2010
    Posts
    11,163
    Quote Originally Posted by Escobert View Post
    so this guy? http://kalinkaoptics.com/mounts/ak-v...aver-rail.html
    Thanks for the info guys! I agree I think saving a bit more and getting something nice for it will work out in the long run. Thanks again.
    According to your link:

    This is a standard height model, a low profile version is also available.
    I would seek out the low profile version it speaks of.

    Or spend extra and get the RS products side rail mount. Supposedly its the best around. Thats what will go on my O-pap one day.
    "I'm fucking furious, I'm violently angry, and I like it. If you don't know what that feels like then I feel bad for you"

  13. #13
    Senior Member Escobert's Avatar

    Join Date
    Oct 2011
    Location
    Soviet State of Vermont
    Posts
    110
    Yeah i saw the low pro, but wasn't sure if it was what I'd want. thanks again!

  14. #14
    Contributor 02/2014 FunkyPertwee's Avatar

    Join Date
    Jul 2010
    Posts
    11,163
    Quote Originally Posted by Escobert View Post
    Yeah i saw the low pro, but wasn't sure if it was what I'd want. thanks again!
    You would only go higher profile if you plan on using a scope with a large bell and you need the extra clearance.
    "I'm fucking furious, I'm violently angry, and I like it. If you don't know what that feels like then I feel bad for you"

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •