Any VEPR owners given this a whirl?

[roodyjay]

I think it could be a nice answer to other furniture options.

http://www.dinzagarms.com/vepr/vepbor2.html

[Fire4Effect]

I've tried theirs. Decent product. We came up with a solution that costs less and is made for the DIY guy.

[TGeneC]

Here is what I have done with my Vepr:
http://store.carolinashooterssupply....earm-Ar/Detail It comes with the mounting ring for the front. I carefully modified the block where it slips into the trunnion. There is a bar that houses one of the rivets that prevents the forearm from sliding all the way in, so I ground it down (slowly and carefully) until it slid right into place, then I drilled a hole in the trunnion that matched up exactly with the tapped hole in the foregrip so I could install a retention screw. Perfect fit and a great look.
For the stock I went with Krebs Customs: http://www.krebscustom.com/PartsPage...kovParts.shtml . This adaptor is specifically for the Vepr - slant cut to fit. I got a pignose adaptor, CAR tube and Vltor stock to finish it off.
I'm also refinishing the walnut stock and forearm. It's going pretty well but I'm not stopping until they glow.

[mikebaker1129]

No, but was going to use one on my saiga.

[itak]

Good info

[mack8384]

I may just have to try that little thingy.. Thanx for the heads up